Alesis i02 Manuel d'utilisateur télécharger pdf (Page 5)

FEATURES

1. USB PORT – Use

the included cable to

connect the iO2

EXPRESS to a

computer. iO2

EXPRESS requires a

USB 1.1 or higher

(e.g. USB 2.0)

connection.

2. MAIN OUT – Use

standard 1/4" cables

to connect this

output to a speaker

or amplifier system.

The level of this

output is controlled

by the MAIN VOL

knob.

3. MIDI IN – Use a

standard five-pin

MIDI cable to

connect this input to

the MIDI OUT of an

external MIDI device.

4. MIDI OUT – Use a

standard five-pin MIDI cable to connect this output to the MIDI IN of an external MIDI device.

5. PHANTOM POWER LED – Lights up when phantom power is engaged.

6. MIDI OUT LED – Flashes whenever MIDI data is sent out of the iO2 EXPRESS.

7. MIDI IN LED – Flashes whenever MIDI data is received from an external MIDI controller.

8. USB LED – Lights up when a USB connection has been established with your computer.

9. LED METERS – Monitors the audio level of the MAIN OUT.

10. MIC INPUT – Connect a microphone to this input with an XLR

cable.

11. GUITAR / LINE INPUT – Connect a line-level device or guitar

to this input with a 1/4" cable.

12. MIC/LINE / GUITAR SWITCH – When this switch is in the

"GUITAR" position, the channel will serve as a high-

impedance input for connecting guitar or bass instruments.

When the switch is in the "MIC/LINE" position, the channel will accept mic or line-level signals.

13. GAIN – Adjusts the channel audio pre-fader and pre-EQ gain level.

14. INSERT – The insert jack allows you to insert a compressor, EQ, or any other signal processor in

between the iO2 EXPRESS's preamplifier and A/D converter.

15. PHANTOM POWER SWITCH – This switch activates and deactivates phantom power. When

activated, phantom power supplies +48V to both XLR mic inputs. Please note that most dynamic

microphones do not require phantom power, while most condenser microphones do. Consult your

microphone's documentation to find out whether it needs phantom power.

16. MONO / STEREO – Adjusts the headphone mix for mono or stereo operation.

17. MONITOR MIX – Blend in any amount of zero-latency signal from your inputs with the output of your

computer.

18. MAIN VOLUME – Adjusts the output volume of the MAIN OUT.

19. HEADPHONES – Connect your 1/4" headphones to this output.

20. HEADPHONE VOLUME – Adjusts the volume level of the headphone output.

NOTE: Do not use the MIC INPUT

and GUITAR/LINE INPUT at the

same time on one channel. This

may overload the channel and

cause distortion.

17 182019

14 14

12 12

10 10

1 2 3 4 5 6 7 8 9 10 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Alesis i02 Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Mélangeurs audio Alesis i02