Alesis 24 Spécifications télécharger pdf (Page 88)

Description of Controls

STUDIO 24 REFERENCE MANUAL 8 7

drum Channels’ L/R switches off, assign them to Group 1/2, and press Group 1/2’s

TO L/R switch. The Group 1/2 faders are now a submaster for the entire drum mix

in the left/right stereo mix feeding the PA or mixdown deck.

MONO SWITCH

Sometimes you may need two separate su/jointfilesconvert/418429/bgroups, instead of a stereo pair. The

MONO switch allows you to do this. When MONO is down, Group 1 will feed both

left and right of the L/R mix, so, for example, it may be used as a vocal su/jointfilesconvert/418429/bgroup. (If

there was no MONO switch and you did a su/jointfilesconvert/418429/bgroup, all the vocalists would wind up

hard-panned to the left side of the mix only.) Group 2 will also appear in the center

of the L/R mix.

GRP 1 AND 2 MASTER FADERS

The two Group Master FADERS adjust the total output level of all signals assigned to

each Group. They get their signal from the GRP switches in the Channels and the

Stereo Aux Returns. They send signal to the two Group output jacks, the GRP

Control Room switches, the LINK TO L/R switches explained above, and to the

DIRECT OUT SOURCE switches in Channels 1 - 8.

Tip: The GROUP FADER of the Studio 24, like the L/R Master, is at unity gain (“0

dB”) when all the way up, not at 2/3 travel as with some other consoles. This

allows you a greater range of control on fadeouts, and makes it easier to “dial in”

the best gain structure, since the “sweet spot” of the fader is in a useful part of

the taper.

L/R MASTER FADER

This is a stereo 60 mm fader with its unity 0 dB position at the top of its travel, like

the group faders. Signal from the L/R output feeds the Control Room switch, and the

top and back panels’ MAIN OUT jacks which are normally connected to a mixdown

deck, or to a PA system.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 104 105

Pas de commentaire

Alesis 24 Spécifications Page 88