Alesis 24 Spécifications télécharger pdf (Page 91)

Description of Controls

9 0 STUDIO 24 REFERENCE MANUAL

2 TRACK TAPE IN

Connect the output of your 2-track (cassette, DAT, CD, reel-to-reel, etc.) to these

jacks. Any stereo source connected here may be heard in the control room mix only.

The RCA jacks accept an unbalanced signal only; you may need to make or purchase

cables that have RCAs on one end if your two-track has different output connectors.

MAIN OUTS

These unbalanced RCA jacks receive the same signal as the top panel MAIN OUTS

but output a -10dBV unbalanced signal. A common use for these outputs is

connecting the Studio 24 to a consumer cassette recorder or similar device. Also note

that the output from these jacks are affected by an effect device plugged into the top

panel MAIN INSERTS.

GROUP OUTPUTS

You may connect these jacks to the first two inputs of a multitrack recorder such as

the Alesis ADAT, whose input normalling feature allows you to go to any of the

eight tracks (Group 1 will feed tracks 1 and 5, etc.). In PA applications, you may

connect these jacks to amplifiers for specific zones (Group 1 feeds a center cluster,

Group 2 feeds side fills, etc.). In broadcast applications, these may be used to provide

“mix minus” or matrix feeds. These jacks are true balanced +4 dBu nominal level

(+28 dBu maximum) outputs on a TRS 3-conductor phone jack.

STEREO AUX RETURNS

These four balanced TRS input jacks are located near the edge of the top panel for

easy repatching. Connect the output of your effects devices, or any other stereo input

that doesn’t require EQ here. Traditionally, the “A” inputs are fed by an effect device

fed by AUX 3 and the “B” inputs by a device fed by AUX 4.

AUX SENDS

The two output jacks, labeled AUX 3 POST and AUX 4 POST, are normally

connected to the inputs of effect devices. The signal output from these jacks is post-

fader, post-EQ. These jacks are 3-conductor TRS with a forward-referenced ground to

avoid ground loops.

MON 1/2

The MON 1/2 jacks may be fed to a headphone amplifier in recording applications

(to be used as the monitor system for the musicians), or to a stage monitor system in

PA applications. Like the AUX SENDS, these jacks are 3-conductor TRS with a

forward-referenced ground.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 104 105

Pas de commentaire

Alesis 24 Spécifications Page 91