Alesis DM5Pro Kit Spécifications télécharger pdf (Page 85)

Programming Drums

DM PRO REFERENCE MANUAL 8 5

Filter, Modulation Wheel to Filter and Filter Envelope to Filter.

P1 The CUTOFF FREQUENCY Parameter

This Parameter sets the basic brightness of the Filter. Like all Filter Parameters, the

Cutoff Frequency Parameter can be overridden by other Filter Parameters, but this is

generally the place to start when constructing a Filter setting.

To set the Cutoff Frequency for an individual Sound, move the cursor beneath the

Parameter Value and then turn the Value encoder:

SND1:FILTER

Frequency: 7 0

Note that a Value of 99 completely opens the Filter, essentially negating it. Similarly,

a Value of 00 completely closes the Filter, cutting

all frequencies and effectively

silencing the Sound.

However, as mentioned above, the other Filter Parameters can also raise and lower

the Filter, so these extreme settings are not necessarily as outlandish as they may

seem when used in conjunction with other Filter Parameters. For example, if you

plan to use the Filter Envelope, it is a good idea to keep the Cutoff Frequency very

low or even at 00 in order to give the Filter Envelope maximum operating range.

P2 The VELOCITY TO FILTER Parameter

This Parameter allows incoming Velocity from either a Trigger or MIDI to

dynamically modulate the Filter Frequency either up or down. Positive Values cause

incoming Velocities to open the Filter (raise the Cutoff Frequency), whereas negative

Values cause incoming Velocities to close the Filter (lower the Cutoff Frequency). The

higher the incoming Velocity (the harder the hit), the greater the effect on the Filter.

To set the amount that Velocity will modulate the Filter, move the cursor beneath the

Parameter Value and then turn the Value encoder:

SND1:FILTER

VELO>FILT: 1 0

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 174 175

Pas de commentaire

Alesis DM5Pro Kit Spécifications Page 85