Alesis 03D Manuel d'utilisateur télécharger pdf (Page 202)

192 Chapter 16—Automix

03D—Owner’s Manual

Fader Return & Trim Edit Modes

The following illustrations show how the return and trim modes affect levels.

These are the original, or previously recorded level changes.

These are the original level changes with the new fader move shown in gray. The two

vertical lines indicate the duration of the fader edit.

With the fader edit complete, the level changes look like this. The level is lowered and

remains the same until the next level change in the previously recorded data occurs.

If trim was on, the level would be lowered relative to the number of fader steps (see trim

on page 190) and the previously recorded level change occurring within the edit period

would still occur.

If return was on, the level would be lowered relative to the number of fader steps (see

trim on page 190) but then return to the level previously recorded at the end of the

fader edit. The TIME parameter determines how long it takes the level to return to the

previous value, and affects only the normal channel faders. It’s recorded as cross fade

data and is listed as XF data on the off-line Event Edit page.

If both trim and return were on, the level would be lowered relative to the number of

fader steps (see trim on page 190) and the previously recorded level change occurring

within the edit period would still occur. At the end of the edit period, however, the level

would return to the level previously recorded, and subsequent level changes would not

be affected. The TIME parameter determines how long it takes the level to return to the

previous value, and affects only the normal channel faders.

Original data

Original data &

new fader move

Trim & Return Off

Trim On

Return Off

Trim Off

Return On

Time

Trim & Return On

Time

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 301 302

Pas de commentaire

Alesis 03D Manuel d'utilisateur Page 202