Alesis HR-16:B Manuel d'utilisateur télécharger pdf (Page 19)

TUNE

The TUNE mode is used to select the desired pitch for each drum pad, and the

click. When it is pressed, its LED will light, and the display will read:

CLICK

PITCH = 0

This display appears when TUNE is first pressed, and the display was not

previously in MIX or VOICE mode for a drum pad. It is used to select the pitch of

the click (metronome). The pitch amount can be changed with the slider,or the

+/- arrow buttons. The range is from -16 to +15. As with the voice mode,

pressing a drum pad will select that drum for pitch editing. Also like in voice

mode, changes made to drum pads are temporary until stored by holding RECORD

and pressing TUNE. See IMPORTANT NOTE under storing voice settings.

MIX

The MIX button Is used to change the volume, panning, and output assignment of

each drum button. When MIX Is pressed its LED lights, and the display reads:

CLICK OUTPUT 1

VOL:65 PAN:. •

This display appears when MIX is first pressed, and the display was not

previously In VOICE or TUNE mode for a drum pad. It is used to select the output,

the volume, and the panning of the click (metronome). The output is selected

with the 1 and 2 buttons of the keypad to select stereo outputs 1 or 2,

respectively. The volume control Is adjusted with the slider (00 to 99), and the

panning is adjusted with the +/- arrow buttons. The panning is seven position,

and the display will show <3, <2, <1, <>, 1>, 2>, or 3>. As with the voice mode,

pressing a drum pad will select that drum for mix editing. Also like In voice

mode, changes made to drum pads are temporary until stored by holding RECORD

and pressing MIX. See IMPORTANT NOTE under storing voice settings.

NOTE: The Volume slider on the front controls output 1 only.

TEMPO

The TEMPO button is used to change the tempo of a pattern or song. The tempo can

be stored with a song, but not with a pattern. While in pattern mode, the tempo

remains at its previous setting until changed. While in song mode, the tempo

changes to the programmed tempo each time a tempo step is encountered within a

song. While in pattern mode, pressing the TEMPO button causes the TEMPO LED to

light, and results in the foliowing display:

TEMPO = J.2 0

BEATS PER MINUTE

Alesis HR-16 Instructions

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 71 72

Pas de commentaire

Alesis HR-16:B Manuel d'utilisateur Page 19