Alesis HR-16:B Manuel d'utilisateur télécharger pdf (Page 68)

2) Press and hold the CLOCK button. The display will read:

CLOCK SOURCE

MIDI & INTERNAL

3) Use the keypad or + and - buttons to select TAPE SYNC IN. The display will read:

CLOCK SOURCE

TAPE SYNC IN

4) Put the tape machine into PLAY. The MMT-8 will automatically start as soon as it

receives the sync tone, causing any other sequencers connected to it to play. Be careful

to return to the beginning of the sync tone since the MMT-8 will automatically begin

playing any time that it receives the sync tone.

START / STOP FOOTSWITCH

The START/STOP footswitch jack is provided for a momentary normally open footswitch

that connects the jack’s tip to its sieeve (ground). While in stop, the footswitch will function

like the play button and start a part or song from the beginning. While in play, the

footswitch acts like the stop button, and stops playing.

REMAINING MEMORY

Holding RECORD and pressing LENGTH causes the following display:

REMAINING MEMORY

too PERCENT

This shows the amount of memory that has not been used. Note that some

operations may not be possible even though it seems that there is still a small

amount of memory available. This is due to the fact that the MMT-8 requires

enough memory to duplicate a part before it can be recorded on, or length changed,

or offset, etc. If a large part is attempted to be altered when there is not enough

memory to complete the operation, the display will indicate that there is not

enough memory available to complete the operation.

CLEARING MEMORY

To clear all of the MMT-8's memory and reinitialize all of its variables, turn power off, press

and hold ERASE, PAGE UP, and PAGE DOWN, and turn on the power while holding

these buttons down for 3 seconds.

Alesis MMT-8 Instructions

Page 28

1 2 ... 63 64 65 66 67 68 69 70 71 72

Pas de commentaire

Alesis HR-16:B Manuel d'utilisateur Page 68