Alesis HR-16:B Manuel d'utilisateur télécharger pdf (Page 32)

B) Keep the Sync signal at about OVU in order to amid dropouts. If the HR-16 does not

see the sync tone for 1/2 second, it will assume that the sync tone has ended and will go

into STOP mode.

C) If possible, do not use any noise reduction, EQ, or signal processing on the sync tone,

D) Amid recording high energy, high-frequency tracks next to the sync track.

TO CLOCK THE HR-16 FROM TAPE SYNC

1) Connect the output of the track of the tape machine that has the sync tone to the TAPE

IN jack of the HR-16.

2) Press and hold the CLOCK button. The display will read:

CLOCK SOURCE

MIDI & INTERNAL

3) Use the keypad or + and - buttons to select TAPE SYNC IN. The display will read:

CLOCK SOURCE

TAPE SYNC IN

4) Put the tape machine into PLAY. The HR-16 will automatically start as soon as it

receives the sync tone, causing any other sequencers connected to It to play. Be careful

to return to the beginning of the sync tone since the HR-16 will automatically begin playing

any time that it receives the sync tone.

USING THE HR-16 AS A SOUND SOURCE

It Is possible to trigger the HR-16 from an external controller suoh as a sequencer,

keyboard, or drum pad controller through MIDI, The HR-16 built in sequencer remains idle

while the external contoller triggers the voices. Bo sure to activate MIDI / UTIL #2 RECEIVE

MIDI DRUMS ON. If this is set to OFF, it will not be possible to trigger any voices on the HR-

16 from the controller.

MIDI program change commands sent to the HR-16 can access patterns. MIDI /UTIL #6

MIDI PROGRAM PATT SELECT must be sat to ON to activate this function. This feature

was designed to give external MIDI controllers access to different sound set ups stored In

any of the 100 available patterns.

IMPORTANT NOTE: VOICE, TUNE, AND MIX ASSIGNMENTS CANNOT BE

STORED IN AN EMPTY PATTERN UNLESS THE LENGTH HAS BEEN

CHANGED TO A LENGTH OTHER THAN 8 BEATS.

START/STOP FOOTSWITCH

The START/STOP footswitch jack Is provided for a momentary normally open

footswitch that connects the Jack's tip to its sleeve (ground). While in stop, the

footswitch will function like the play button and start a pattern or song from the

beginning. While in play, the footswitch acts like the stop button, and stops

playing.

Alesis HR-16 Insfructlons ..................................................................................................................................... Page 26

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 71 72

Commentaires sur ces manuels

Pas de commentaire

Alesis HR-16:B Manuel d'utilisateur Page 32

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de musique Alesis HR-16:B